BETAFPV ExpressLRS ELRS Nano Receiver 2.4G / 915Hz Long Range Latency

Wide Selection Available

A ton of ExpressLRS items are in stock now! From receivers to accessories, everything you need for a complete setup is ready to ship.

Ideal for Micro Drones

For micro drones or smaller builds, we highly recommend the compact Lite receiver—it saves space without compromising performance.

Must-Have: Recovery Dongle

We suggest adding an ExpressLRS Recovery Dongle to your toolkit. It’s essential for unbricking a receiver if firmware flashing goes wrong.

Choose the Right Receiver

Selecting a suitable ExpressLRS receiver is crucial for stable and responsive control of your quadcopters or RC models. Match the receiver to your build for the best flight experience.

Complete Lineup for Every Need

Our range of receivers—including ELRS Lite, Nano, Micro, and the latest SuperD—meets the diverse needs of FPV pilots, whether you're racing, freestyle flying, or cruising long-range.

Choose the Right Receiver

Betafpv ELRS Nano Receiver 2.4G/915MHz version diagram as shown below.

Enable the corresponding UART (e.g. UART3 below) as a Serial Rx on Betaflight Configurator "Ports" tab.

On the "Configuration" tab, select "Serial-based receiver" on the "Receiver" panel, and select "CRSF" as the protocol. Telemetry is optional here and will reduce your stick update rate due to those transmit slots being used for telemetry.

Nano receiver could enter binding status by power on/off three times.

● Plugin and unplug nano receiver three times;

● Make sure the LED is doing a quick double blink, which indicates the receiver is in bind mode;

● Make sure the RF TX module or radio transmitter enter binding status, which sends out a binding pulse;

● If the receiver has a solid light, it's bound.

Note: Binding once and the receiver will store the binding information. Re-power and the connect successfully auto.

The connection between the ELRS Nano receiver and the FC board is shown below.

Specification

● Weight: 0.7g (receiver only)

● Size: 12mm*19mm

● Telemetry power: 20dbm (100mW, 2.4G Version)

● Frequency bands (2.4G version): 2.4GHz ISM

● Frequency bands (915MHzversion): 915MHz FCC

● Input voltage: 5V

● Antenna connector: IPEX MHF

● Cable Length: 46mm

Parameter Data

Recommendation